香蕉视频在线精品视频

    1. <kbd id="7o2am"><button id="7o2am"></button></kbd>

      1. <sup id="7o2am"></sup>
            1. <kbd id="7o2am"></kbd>

              Influence of laser cutting machine's optimal speed on cutting quality

              06, 2020

              by tianchen01

              Influence of laser cutting machine's optimal speed on cutting quality


              How to cut the board with high quality effect, how to pass some very demanding requirements.

              Today, let's talk about how to choose the most suitable speed to cut out high-quality materials.


              The power of the laser will affect the speed of the laser equipment cutting the plate, and the cutting speed of the laser equipment will affect the cutting quality of the plate. Under the condition of a certain laser power, there is an optimal cutting speed range. If the speed is too fast or too slow, it will affect the flatness of the surface of the cutting material.


              太快.png

              fast speed cutting effect

              太慢.pngslow speed cutting effect
              合理.pngReasonable speed cutting effect


              Cutting speed is too fast

              1. The laser beam and the material are in contact with each other for a short time,

              which may result in the inability to cut and sparks.

              2. Some areas can be cut, but some areas cannot.

              3. Causes the entire cutting section to delaminate.

              4. As a result, the board cannot be cut in time, 

              the cutting section shows a diagonal stripe road, 

              and the lower part of the melting spot is generated, 

              as shown in the following figure.


              Cutting speed is too slow

              1. The time of interaction between the material and the laser increases, 

              resulting in over-melting of the cutting plate, and the cutting section is rough.

              2. The slit will widen accordingly, causing over-burning in the smaller rounded or sharp corners, 

              and the ideal cutting effect cannot be obtained.

              3. The cutting efficiency is low, which affects the production capacity.


              Judging method of cutting speed

              1. The cutting speed is reasonable: the cutting sparks spread from top to bottom, 

              the cutting surface is stable, and there is no molten slag in the lower part;

              2. The cutting speed is too fast: the cutting spark is inclined;

              3. The cutting speed is too slow: the cutting sparks are non-diffusive and few, condensing together.

              太快1.pngThe spark tilting speed is too fast
              太慢1.pngThe spark does not spread too slowly
              正常.pngThe speed of spark spreading from top to bottom is reasonable


              fiber laser cutter (3).jpg

              Top 1 Super-Wide Fiber Laser Cutting Machine TC-H


              Tianchen independent research and development design, H1230 adopts "double straight" air duct structure, 24 dust removal ports, first Unique double operation control screen, main body adopts bridge design, It solve the most customer cutting accuracy, speed, dusk removal problem. At now it is the No.1 supper wide fiber laser machine in china. 



              For more information or solution.Please contact us or leave a message to us quickly, we will let you enjoy this service as soon as possible !

              0Comments

              Leave a comment

              your email address will not be published. required fields are marked *

              Submit
              PREVIOUS Laser cutting machine cutting 7 kinds of metal,tips about high quality cutting
              ?Tianchen Laser deploys in the Brazilian market NEXT
              香蕉视频在线精品视频
              1. <kbd id="7o2am"><button id="7o2am"></button></kbd>

                1. <sup id="7o2am"></sup>
                      1. <kbd id="7o2am"></kbd>